Free Practice Test Aws API 1104

Q:-Lineup clamps shall be used for butt welds in accordance with the procedure specification. When it is permissible to remove the lineup clamp before the root bead is completed:

Posted on


1. The completed part of the bead shall be in approximately equal segments spaced approximately equally around the circumference of the joint. 

2. The completed part of the bead shall be removed and rewelded after removing the clamp. 

3. The completed part of the bead shall be peened before removing the clamp. 

4. The completed part of the bead shall be at least 4 inches long for all pipe sizes 

5. None of the Above

This entry was posted in API 1104 Exam Preparation, AWS CWI Exam Part B Practical Questions, AWS CWI Questions and tagged , , , , , , , , , , , , , , , .

Q:- For welder qualification, the specimens shall be prepared for tensile-strength, nick-break, and bend tests. When tensile-strength tests are omitted:

Posted on


1. The welder is not qualified
2. The weld must be redone
3. The is not covered in API 1104
4. Tensile-Strength specimens shall be subject to the nick-break test
5. Extra face bends must be tested

This entry was posted in API 1104 Exam Preparation, AWS CWI Exam Part B Practical Questions, AWS CWI Questions, Interview Questions and Answers, Piping Interview Questions Answers, Questions Answer for AWS D1.1 and tagged , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , .

Q:-In the welding of a butt joint made from one side, which of the following controls the profile of the root bead :

Posted on


  • Root face.
  • Bevel angle.
  • Root gap.
  • None of the above.

This entry was posted in AWS CWI Questions and tagged , , , , , , , , , , , , , , , , , .